Roofing Benton City homes the way we have since 2002 — measured on site, priced in writing, and finished the way we would want our own roof finished.
From a single lifted panel to a full tear off, we handle every roofing job a Benton City, WA home is likely to need.
Standing seam and metal panel roofs, measured and cut on site. We help you settle on a color, set the panels straight, and trim the ridge and valleys so the whole roof sheds water the way it should.
Hail bruises shingles and dents the softer metal on vents, valleys and gutters. We show you what we find and document it properly for the claim.
When a roof is genuinely finished we replace it, and we say so plainly rather than dressing it up. Metal and shingle priced side by side so you can compare real numbers.
We work around your hours, weekends included when that is what it takes to keep your doors open while the roof goes on.
Water runs along decking and rafters before it ever drips, so the stain is rarely under the hole. We trace the leak back to where it really starts and fix that.
An older roof deserves to keep its character. We repair rather than replace wherever the material still allows it.
Coatings for low slope and older metal roofs that are still sound but weathered. Washed down, refastened, primed at the rust, then coated.
Squirrels, wasps and water all treat a soft soffit as a front door. We close it up properly instead of patching over it.
Old skylights leak at the flashing long before the glass ever fails. We reflash, reseal, or set a new unit and tie it in properly.
We still shingle plenty of roofs. Cracked, curled and blown off shingles get replaced, and the valleys and flashing get reworked while we are up there.
Missing shingles get matched as close as weathering allows. Loose metal gets new fasteners and washers, and the eaves, rakes and ridge get sealed back up tight.
Backed out screws, split washers, rust starting at a seam, a panel lifted at the eave. These are our roofs, and most of the time a repair is all it takes.
We repair what the storm actually broke. If that is one slope, we do one slope, and we will not pad an estimate to make a claim look bigger.
Steam and hand work, never a hammer and chisel on your roof. Then we check the eaves for the damage the ice already did.
Porch roofs, additions and low slope sections that hold water instead of shedding it. We rework the flashing, seal the seams, and get water moving again.
Buying, selling, or just want to know how many years you have left? We look, we tell you, and we do not turn it into a pitch for a roof you do not need.
Guards installed as part of a roof job or on their own. Either way we check the hangers and the pitch while we are up there.
Temporary cover goes on fast, then we come back and make the permanent repair once we can see properly what we are working with.
Waterproofing details on additions, porches and low slope tie ins, where two roofs meet and most leaks quietly begin.
Lifted panels, missing shingles, flashing that has given up where the chimney comes through. We find what is actually wrong, fix that, and leave the rest of your roof alone.
Estimates are always free. That line has been on everything we have printed since 2002 and it still is. Somebody comes out to your Benton City home, gets on the roof, looks in the attic if there is a way in, and leaves you a written price.
No pressure and no price that expires if you do not sign that day. If your Benton City roof needs a repair rather than a replacement, we will tell you so, even though the repair is the smaller ticket.
A family roofing company that has kept the same habits since 2002.
The same family started this company putting metal roofs on neighbors houses in 2002. It has never been sold, franchised or handed off to a call center.
Standing seam and metal panel roofs are the work we are known for. Color, trim, fastening pattern — we have done hundreds and we will walk you through all of it.
You get a start date and we hold to it. If weather moves your job we call you, rather than leaving you watching the driveway.
Beds get covered, tear off gets hauled as we go, and a magnet goes over the drive before we pull out. Your yard should look like we were never there.
Somebody comes out, measures, gets on the roof, and leaves you a written price. No charge, no obligation, and no number that expires if you do not sign today.
Wondering about metal versus shingle, or what a new roof runs in Benton City? Start here.
A typical Benton City shingle roof runs roughly $8,000 to $18,000 in 2026 for an average single family home, and more if the deck has rot or the roof is steep and cut up with dormers. We do not price off a satellite photo — somebody comes out and measures.
A metal roof installed properly on a Benton City home should give you 40 to 60 years, and standing seam often goes longer because there are no exposed fasteners. Screws and sealants on a panel roof want attention around year 20, which is a small job next to a re-roof.
Often, yes. Plenty of the Benton City roofs we get called to look at need flashing reworked or a section refastened, not a whole new roof. We will tell you honestly which one you are looking at, and if it is repairable we would rather repair it.
Most Benton City houses are a two to four day job. A straightforward shingle roof can be done in a day or two. A cut up metal roof takes longer because every panel, valley and trim piece is measured and fit on site rather than pulled out of a box.
Much less than people expect. Over solid decking with underlayment under it, a Benton City metal roof sounds about like a shingle roof from inside the house. The loud tin roof people remember was screwed straight to open purlins over a barn with nothing underneath.
Sometimes. If the decking is sound and there is only one layer of shingles, a Benton City metal roof can go over the top on purlins. If there is rot underneath or two layers already on, we tear off first — and we will tell you that before you sign, not halfway through.
What people say once the crew has packed up and gone home.
"Standing seam on our log home. The panels are dead straight and the ridge work is clean. You can tell they have done a few of these."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Green metal over the whole house and the carport. Looks sharp, and it is quiet inside when it rains, which honestly surprised me."
We take care of homeowners in these neighboring communities as well.